How to use IPL device
- Shave the area of the body you want to treat.
- Clean the device ‘flash screen’ using alcohol wet-wipes or soft microfiber cloth used for cleaning a glass.
Press the “power button” for 2 second, let the device start and then enter it into a working state.
Step:2
Click the “power button”, to select the intensity level.
Each time you press the “power button”, the light intensity will gradually increase from 1st gear to 8th gear. After the 8th gear press “power button” the light intensity level will gradually decrease until 1st gear.
There are 8 intensity levels indicated by a digit on the IPL display screen. The diagram below shows the intensity level from low to high power.
Level 1 is the minimum power intensity.
Level 8 is the maximum power intensity.
Any adjustment can be made in the sequence shown below with the click of the ‘power button’.
The device has two flash mode; 'MANUAL' and 'AUTO'
Press and hold the 'Flash Button' for 2 seconds to switch modes between 'Auto' and 'Manual' as show in the diagram below:
Step:3
- Once the intensity level is set.
- Place the device ‘flashing screen’ on the desired skin area of the body covering the complete ‘flash screen’ of the device.
- The device will flash one time.
- Repeat the process for the other parts of the skin.
Step:4
If the device is left ‘idle’, it will go in to stand-by mode. Click the ‘power button’ to wake it up.
Note : On restarting the device the intensity level will return back to level 1.
Step:5
Press the ‘power button’ for two seconds to shutdown the device when finished using.
